These are in stock ready to ship!

As the leader in Custom Corvette products especially the Tail Light and smoked marker lights we are again the first to create this kit. Others will follow but none can be GScreations!

What you get: This is a 4 piece kit. This kit is for the large "L" shaped parking light covers only in a poly-carbonate lexan transparent smoked blackout look. (You can use the drop down to add the reflector overlays if desired).

What they fit: 2020, 2021, 2022, 2023, 2024+ C8 Corvette All trim levels with factory C8 Corvette tail lights.

Material: Our covers are molded from 1/8'' thick Poly-carbonate lexan. (Poly-carbonate aka lexan, is a tough and durable plastic material which is virtually unbreakable with 250 times the impact strength of glass and 30 times that of acrylic.) What does this mean to you...they will not break when installing, removing or heck even if you drop them unlike their predecessor C7 blackouts which were made from acrylic. The smoked color is built into the lexan so no worries about paint fade, peeling or chipping over the years.

How they install: Amazingly simple!! Since ours is only 4 pieces total it will take you under 2 minutes. Each cover will come with pre-installed clear 3m tape. You simply clean your lights with the supplied alcohol, and let dry. Once dry remove the red tape backing and press on firmly for a few seconds. That's it! You do not need to remove your rear bumper to install these covers.

These covers by design do not create an air or water tight seal. They were designed with water channels to allow water to flow through them. This simply means hassle free maintenance, if you see any dirt or grim between the factory light and the new cover simply spray water along the top or side edge to wash it away.

It is 100% completely normal to see a whitish fog after a wash or driving in rain. This is just condensation and will completely go away when dry. Dry time will depend on many factors with relative humidity playing a large role in that time. The photo below shows this normal condensation.

When you use your Parking lights they are still highly visible. We have been using this level of smoke on all of our lights since the C5 Corvette! 

Optional Re-install Clear Tape Kit: Plan on removing these in the near future? If so and would like the same tape that we use on these covers, please us this link C8 Corvette Tail light Smoked Lens cover Blackout Re-install Clear Tape Kit

If your vehicle was ever waxed or ceramic coated most likely so was the area you are installing this product on even if it's a light or reflector. You MUST remove any wax or ceramic coating before you install this product or the 3m tape used will not stick. Alcohol alone will not do this, please consult with your detailer to find the best way to remove. You should test the area before install by putting any tape on the light and if there is good adhesion you should be okay. If the tape you used for the test does not stick or comes off very easy so will our covers.